I have a 50’ (15.25 m) extension electrical cord on a wind-up reel.
It has a separate 10’ (3m) cord from the reel hub, to plug into the wall outlet.
All I want is a way to plug it into the wall and be able to unreel it as I work, without that 10’ section getting all twisted. Kind of like a phone cord detangler (pic below), or the brake cable detangler/gyro on BMX stunt bikes.
I was trying to think of a way to make one but apparently it’s a “dangerous fire hazard” or whatever.
Get a regular extension cord, find the mid-point, and feed it through the rollerdrum or duct-tape it on. Roll the cord onto the drum such that both ends are being rolled in the same direction. When finished, you will have a male and female connector readily available from the end of the drum, and uncoiling it will give you an equal length of both sides.
I have a 50’ (15.25 m) extension electrical cord on a wind-up reel. It has a separate 10’ (3m) cord from the reel hub, to plug into the wall outlet.
All I want is a way to plug it into the wall and be able to unreel it as I work, without that 10’ section getting all twisted. Kind of like a phone cord detangler (pic below), or the brake cable detangler/gyro on BMX stunt bikes.
I was trying to think of a way to make one but apparently it’s a “dangerous fire hazard” or whatever.
Get a regular extension cord, find the mid-point, and feed it through the rollerdrum or duct-tape it on. Roll the cord onto the drum such that both ends are being rolled in the same direction. When finished, you will have a male and female connector readily available from the end of the drum, and uncoiling it will give you an equal length of both sides.