I recently switched from wireless to wired headphones (Samson SR-850, probably the best for the very reasonable price) and my chair’s wheels instantly started eating its cable. Right now I’m using a small plastic hook that came with a face mask to keep it off the floor, but I’d like to hear other solutions.

  • Kit@lemmy.blahaj.zone
    17·
    9 months ago

    I run the cable on top of my desk instead of under. Makes the desk look more cluttered, but no risk of catching the cable in the wheels.

    • federalreverse-old@feddit.de
      3·
      9 months ago

      I wish that worked for me. The armrest of my chair catches onto every bit of cable it finds slightly hanging off the table. Granted, that’s only an issue because the armrest is T-shaped rather than O-shaped.

    • KISSmyOS@feddit.de
      22·
      9 months ago

      Do you want cats on your desk? Cause that’s how you get cats on your desk.

  • criitz@reddthat.com
    7·
    9 months ago

    I have a hook on the cabinet next to my desk that I hang my headphones on when not in use, but that the cable is also attached to. This keeps it out of the way. So the cable is basically hanging between the cabinet and my head. The cable also separates in the middle, so it tears away if I accidentally get up and walk away with them on.

    • sbv@sh.itjust.worksEnglish
      2·
      9 months ago

      I do the same. I have a few different headsets so it’s nice to have somewhere to put them.

  • Jarlsburg@lemmy.world
    6·
    9 months ago

    I used a coiled cable and put my audio interface to my side higher up on a shelf. That way when I am seated the headphone cable barely touched the ground.

  • KoboldCoterie@pawb.socialEnglish
    6·
    9 months ago

    There’s very cheap cable holders for VR applications that attach to your wall or ceiling (non-destructively) and hold cables above you. I used those above my desk to hold the headphone cables, so the cable runs up the wall behind my desk, and then over my head. Keeps it off the floor and away from everything else.

  • communism@lemmy.ml
    3·
    9 months ago

    Roll up the excess cable into a loop and sellotape the loop to stay in a loop. Maybe looks ugly but nobody else sees it lol.

  • Extras@lemmy.today
    3·
    9 months ago

    I made my own anchor points with some mason line, a broken DVD case and double sided tape been going on for 4 years now. Think there’s adhesive cable clips too that comes with several for cheap so you don’t have to go through my dumb idea just prepare the area by cleaning it with alcohol first

  • Desso@lemmy.world
    1·
    9 months ago

    The cable on the Grado SR60X and her siblings are comically long. They are pretty thick too, so I decided to braid them up, reducing their length from 2 down to about 0.6 metres. You can look up some easy guides on YouTube for this.

  • Arfman@aussie.zone
    1·
    9 months ago

    I got this thing called the J22 that I can plug my wired headphones in and put it my pocket or clip to my shirt that then connects via Bluetooth. No more issues with getting wires caught to stuff and no lag.

  • Pantherina@feddit.de
    1·
    9 months ago

    I drilled long screws in a shelve, wrapped it with thick paper and ducttape. Works like a charm.